If you open the back cover on your blink xt2 camera you will find a small switch beside the right battery slot.
Blink security camera turn off blue light.
There is no small red light that shows it s recording.
Remove the battery cover.
To see how to do that click here.
To the right of your camera.
This article will show you how to turn off the blue recording led on blink xt.
As far as the blue indicator light just cover it with electrical or white tape if it is an issue.
This feature is not available on the blink indoor cameras.
For all cameras other than the indoor the blue light can be turned off.
Camera is starting up.
The recording light is blue and that can be shut off.
With the release of blink xt we have been able to add a feature to it to allow you to toggle the blue recording light.
By confirmation there is no red light during daytime.
I guess it is a pro burglar security feature.
Firmware update in progress.
This led is enabled by default from the factory.
Honestly i don t know how the blink folks seem to think having the light come on only when its recording and off when its not is a security feature.
The xt and xt2 cameras have a hardware switch inside the battery compartment to control the blue recording light.
Very slow pulsing light blue.
Camera is in setup mode.
If you turn off ir illumination the red light disappears but of course you have no night vision.
If you are talking about the bright light that comes on with the motion just set the illuminator control to off.
The red light you see is the ir illuminator.
There are no other red lights.
I have a write up on my blog kentavos.
You can always turn it back on at night.
In this guide i will show you how to disable this light.
Applies to xt and xt2 cameras only.
This article will show you how to turn off the blue recording led on blink xt.
This feature is not available on the blink indoor cameras.
Take a look at the photograph below.
Have a paperclip ready to go and put it to the side go to the cloud button on the app after you press it it probably says sync module is off line.
If you own a blink security camera you have probably noticed that the camera displays a blue led light whenever it is recording motion.
This led is enabled by default from the factory.
Light blinks on for.
I just wanted to help anybody who has this issue apparently my internet went down while i was sleeping to fix the problem do this.
I got an alert that my blink was offline the blink box had a solid blue light and a green flashing light.
Blink xt and xt2 have a physical hardware switch inside the camera to control whether the status light is on or off.
Slow blinking pattern blue light.
Light blinks on and off then is on for two seconds blue.
